The retransmitter amplifies your VF 433MHz signal and sends it at a greater distance to your receiver, alarm or garage door.

The retransmitter amplifies your VF 433MHz signal and sends it at a greater distance to your receiver, alarm or garage door. You can extend the distance of your remote control to virtually anything that radio protocols allow.

If the distance between the alarm and the controller is too large, or they have too many obstacles, you can use this signal repeater to receive and transmit RF signals. The device can also long out the range of the alarm itself to the PIR detector, in addition to some branded alarms. ( untested paradox, jablotron)

The device operates to a distance of about 200 meters (wireless range).

External power supply: DC 9V-14V

Static current: <25mA

Operating current: Reception and transmission frequencies: 433 MHz

Maximum number on remote control: 20ks

receiving / carrying distance: 200 m - 900 meters.

The device should be used if the distance between the alarm host, the detectors, the controller is too large, or have many obstacles. To resolve this issue, you can install the wireless signal repeater anywhere in the middle of the distance. This device may transmit the alarm system host signal and accessories, extend the distance of the transmitting and receiving signals.

Wireless intelligent coding can be adapted to some extent by your remote control, compatible with PT 2262 normal encoding (Resistance 1.5 M - 4.7M) (Resistance 150 K - 470 K).

Also, the device is compatible with the 1.524 and 2.262, 2262 and 1527 coding chip remote control detectors.

The built-in EEPROm chip in or off mode, information, activation/deactivation status, remote control code, and detector will not be erased.