The use:

Widely used in various areas of aviation, at civil airports and in unobstructed airspace, helipads, iron towers, chimneys, ports, wind farms, bridge and urban high-rise buildings

where it requires an air traffic warning.

It is usually used over 45 m and less than 150 m of buildings.

Features:

• The light cover uses a PC with anti-UV, which is a highly efficient light transmission of up to 90%, relatively high impact resistance and very well suited for bad environments;
• The house light is made of aluminum alloy and painted with plastic spray, the structure is high strength, corrosion resistance;
• Use a special optical reflector design, visual range further, more accurate angle, no light pollution.
• The light source uses high-quality LEDs, a lifespan of up to 100,000 hours, low energy consumption, energy efficiency and environmental protection.
• Based on single-chip computer control, the signal of automatic synchronization identification, they do not distinguish between the main and auxiliary lights and can also be controlled by a controller.
• The same voltage of the source with a synchronous signal, integrate into the power cable, eliminate damage caused by incorrect installation.
• She used a photosensitive probe suitable for the natural light spectrum curve, the level of automatic light intensity control.
• The light circuit has a surge protector to make the light suitable for harsh environments
• Integrated design, IP65 protection lever
• GPS sync is available

CK-13 Medium intensity obstruction light type AB Installation and use:

（1） Install the light on a horizontal surface that has sufficient strength.

（2） When installing, do not place the photocell face down near a light source, nor can it be hidden from nearby objects.

（3） Line identification, bulbs with one three-core cable: brown and black line is electrical line, brown wire is live wire (L), black wire is zero (N); the yellow-green wire is the ground wire.

（4） Connection:

Answer: When the bulbs use one, the brown wire is connected to the live wire, the black wire to the neutral wire, the yellow-green ground wire, then the light can operate normally;

B: When it is necessary to synchronize more than one light, all brown wires of all lights are connected to the live line, all black wires are connected to the zero line, yellow-green connection

grounding, all connections of the lights together can achieve flashing synchronization within approximately 10 minutes

（5） When testing the GPS sync function, do it outdoors and without shadows, it will take about 10 minutes. （Only for GPS sync type）

Installation method:

Common installation methods for this product include vertical side installation, vertical installation, hoop and plywood mounting (see figure below). For steel construction

glass curtain, fan, communication tower, chimney and other structures The upper installation must design the support bracket according to the specific structure of the installation position.

Maintenance:

The shade needs to be cleaned every six months or one anniversary. Cleaning requires a soft cleaning tool. A hard cleaning tool cannot be used to prevent the bulb cover (plastic material) from being scratched.

Packing / storage:

• The bulb package has one package and four packages according to actual needs. The outer packaging is made of a 5-layer corrugated paper box with a thickness greater than 5 mm, which is protected by anti-collision, impact-resistant and anti-stress pearl cotton.
• Each box contains operating instructions, a product qualification certificate and a factory inspection report.
• Luminaires with packaging must be stored in an environment where there are no changes in ventilation, drying and temperature difference.

Warning:

• All cables must be connected correctly, otherwise the light may be damaged. Read the brand and introduction carefully.
• The power supply of this type of light is AC100V-240V. Do not use another power supply, such as 380 V, otherwise the light will be damaged quickly.
• To prevent lightning strikes, it is forbidden to install the lamp on the top or edge of the iron tower (if necessary, it can add a light limiter to the outside of the bulbs).
• The temperature rises during work, this is a normal situation.
• When the light is working, to avoid danger, do not open any part of the light body.
• This product is a sealing structure. If non-professional technicians do not fall under the tool, otherwise we are not responsible for warranty repairs.