Application:

Widely used in various areas of aviation, at civil airports and in unobstructed airspace, helipads, iron towers, chimneys, ports, wind farms, bridge and urban high-rise buildings

where it requires an air traffic warning.

It is usually used over 45 m and less than 150 m of buildings, it can be used alone, it can also be used with medium OBL type B and low intensity OBL type B together.

Features:

• The light cover uses a PC with anti-UV, which is a highly efficient light transmission of up to 90%, relatively high impact resistance and very well suited for bad environments;
• The house light is made of aluminum alloy and painted with plastic spray, the structure is high strength, corrosion resistance;
• Use a special optical reflector design, visual range further, more accurate angle, no light pollution.
• The light source uses high-quality LEDs, a lifespan of up to 100,000 hours, low energy consumption, energy efficiency and environmental protection.
• Based on single-chip computer control, the signal of automatic synchronization identification, they do not distinguish between the main and auxiliary lights and can also be controlled by a controller.
• The same voltage of the source with a synchronous signal, integrate into the power cable, eliminate damage caused by incorrect installation.
• She used a photosensitive probe suitable for the natural light spectrum curve, the level of automatic light intensity control.
• The light circuit has a surge protector to make the light suitable for harsh environments.
• Integrated design, IP65 protection lever
• GPS sync is available

CM-15 Perimeter light of medium intensity obstacle, connection type A:

Distinguish 1） Cable discrimination: This light has a 3-core cable in which the brown and black lines represent the power line (AC220V). The brown line is the living line (L), the black line is the zero line (N), the yellow green line is the Earth line.

Instructions 2 instructions Wiring instructions:

a. when connecting one unit, it is necessary to connect the brown live line (L), the black zero line (N) and the yellow-green earth line.

b. when connecting more than one unit, it is necessary to connect the brown live line (L) of all lights, the black zero line (N) and the yellow-green ground line. And GPS can make them

flashes synchronously within 10 minutes.

（3） The GPS synchronization mode should be tested externally without cover. Synchronization may take 10 minutes.

Installation method:

Common installation methods for this product include vertical side installation, vertical installation, hoop and plywood mounting (see figure below).

For glass hinged wall of steel construction, fan,

communication tower, chimney and other structures The upper installation must design the support bracket according to the specific structure of the installation position.

Maintenance:

The shade needs to be cleaned every six months or one anniversary. Cleaning requires a soft cleaning tool. A rigid cleaning tool cannot be avoided

scratched bulb cover (plastic material).

Warning:

• All connections must be correct, otherwise it will damage the lights, please check the mark and instructions.
• The power supply is AC220, it cannot use another power supply, otherwise it will damage the lights.
• The obstruction light must be installed under the lightning conductor or lightning protection zone in the event of lightning strikes.
• It is normal for the temperature to rise during operation.
• Do not open any part of the lights during operation.
• The light is completely sealed, do not install or disassemble unless you are a professional. Improper use, our company does not guarantee.